Quick Overview

• Use all specified fasteners. See General Notes.
• Install before concrete pour with a StrapMate, or other holding device.


• Nail strap from the bottom up.


• Strap may be bent one full cycle (bent horizontal 90° then bent vertical) to aid wall placement, but may cause spalling behind the strap. If the spall is 1" or less, measured from the embedment line to the bottom of the spall, full loads apply. 1" to 4" spalls for LSTHD8 achieve 0.9 times table loads. STHD10 and STHD14 achieve full load for spalls less than 4". Any portion of the strap left exposed should be protected against corrosion.


• Other than where noted in the two-pour detail, do not install where:


• (a) a horizontal cold joint exists within the embedment depth between the slab and foundation wall or footing beneath, unless provisions are made to transfer the load, or the slab is designed to resist the load imposed by the anchor; or 


• (b) slabs are poured over concrete block foundation walls.


• Additional studs attached to the shearwall studs or post may be required by the Designer for wall sheathing nailing.


• Wood shrinkage after strap installation across horizontal members may cause strap to buckle outward.